Swimbait Insert Weight (Line Thru) 4 Cavity

  •  - Click to enlarge
  •  - Click to enlarge
  •  - Click to enlarge
  •  - Click to enlarge
Swimbait Insert Weight (Line Thru) 4 Cavity

Tap for gallery


(Quantity discounts available)

Product Information
Quantity Discounts

This swimbait insert weight mold is available in 3 sizes.  1/4, 3/8, or 1/2 oz.  If you buy all three sizes (at the same time) an automatic discount is applied.  The pull pin is 3/32 inch in diameter. 

You may notice only one side of the mold has a casting sprue and gate into the cavity.  This is deliberate so that you do not crash the thru hole when you cut the insert at the gate.  

The intended application is to place this in a mold and pour the swimbait around them.  For best use it is suggested that you paint or powder coat using a plastisol safe coating before using.  

Product CodeSB-Insert-LineThru
ManufacturerCNC Molds N Stuff

You can save money on this item when you purchase several at a time. The table below shows the minimum quantities required to benefit from this offer, and how much they'll cost.

QuantityPrice per unit

Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

Please enter a valid email address.
This field is required.

eCommerce by CubeCart